Datacom-systems SS series SPAN Instrukcja Użytkownika Pobierz pdf (Strona 21)

Datacom Systems Inc

SPAN and Multi-Link Aggregators/Regenerators • USERguide

MONITOR:

These ports are either RJ45 or duplex-LC connectors used for connection to

NIC

MONITOR

card connectors of each network monitoring tool. network con-

nections. The LED Display Code Table deciphers the RJ45 jacks with inte-

grated LEDs that display line status and line speed of each port. The LED

associated with each duplex-LC jack indicates when light signal has been

detected on the respective Rx

MONITOR

port.

Application & Hardware Installation — Figure 13

through Figure 15 depict typical application installations of VERSAstream

™

SPAN

aggregator/regenerator series models.

‘Dual-Homed’ Server Application — shown in Figure 13, focus-

es on monitoring and analyzis of the

“Dual Homed” Server Distribution Network. This

VS-1022SX-SX is similiar to other VERSAstream

™

SPAN series installations:

To connect the VERSAstream

™

VS-1022SX-SX

SPAN Series aggregator/regenerator,

refer to Figure 13 and follow these steps:

1. Two power supplies are provided. Use of the second power supply is strongly

recommended to assure uninterrupted monitoring. Connect both power supply

barrel connectors into the power 1 and 2 ports, respectively, of the VERSA-

stream

™

. Plug the power supplies into the external power source, furthermore,

connecting the second power supply to a different external power source circuit

than the first power supply eliminates power as a single point of failure. The

POWER 1 and 2 LEDs illuminate indicating power 1 and 2, respectively, are on.

Either LED not illuminated indicates a defective power source and immediate

replacement is required to insure redundant power integrity.

Figure 13 - VS-1022SX-SX Hardware Installation

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Brak uwag

Datacom-systems SS series SPAN Instrukcja Użytkownika Strona 21